|
[Sponsors] |
February 24, 2010, 20:13 |
Skweness in a Mesh for Cfx-solver
|
#1 |
Member
|
hello, im working in a combustion simulation with ansys 12, and im using for the mesh generation, the Meshing (ansys AI*environment) with patch conforming method.
i was reading the tutorial pdf for meshing, and they said, that the skweness(average) for fluent must be low of 0,25 and low standad deviation. my question its, this arguments are the same for an optimal work with ANSYS-CFX 12? in my mesh i has: Skewness: Min=2,10E-6 Max=0,82 average=0,23 standar deviation=,12 thanksvery much |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
Dynamic moving mesh | Pei-Ying Hsieh (Hsieh) | OpenFOAM Running, Solving & CFD | 64 | June 7, 2012 10:04 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
First steps w moving mesh FOAM FATAL ERROR solver table is empty | tehache | OpenFOAM Running, Solving & CFD | 2 | May 14, 2007 04:59 |
compressible two phase flow in CFX4.4 | youngan | CFX | 0 | July 1, 2003 23:32 |