CFX solver workspace properties: modify default values

zboud · March 5, 2010, 10:12

Hi,

Is it possible to modify the default values of the range settings in the monitor properties? I guess there's some file to edit somewhere...

Thanks!

ghorrocks · March 6, 2010, 04:45

From memory you right click on the graph and select properties. I don't have CFX open now so I am doing that from memory so somebody correct me if I am wrong.

zboud · March 8, 2010, 08:10

Yes, right click on the graph, then "Monitor properties", then "Range settings". But I have to do this everytime I monitor a run, that's quite annoying. So I was wondering if there was any way to change the default values...

March 5, 2010, 10:12	CFX solver workspace properties: modify default values	#1
zboud Member prout Join Date: May 2009 Posts: 32 Rep Power: 16	Hi, Is it possible to modify the default values of the range settings in the monitor properties? I guess there's some file to edit somewhere... Thanks!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 15:45
Reynolds Number- CFX Solver	Jwolf	CFX	5	January 23, 2010 19:07
problem in CFX solver about isolated volumes	Yuan	CFX	2	August 16, 2004 22:54
compressible two phase flow in CFX4.4	youngan	CFX	0	July 1, 2003 23:32
CFX 5.5	Roued	CFX	1	October 2, 2001 16:49

March 6, 2010, 04:45		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,365 Rep Power: 139	From memory you right click on the graph and select properties. I don't have CFX open now so I am doing that from memory so somebody correct me if I am wrong.

March 8, 2010, 08:10		#3
zboud Member prout Join Date: May 2009 Posts: 32 Rep Power: 16	Yes, right click on the graph, then "Monitor properties", then "Range settings". But I have to do this everytime I monitor a run, that's quite annoying. So I was wondering if there was any way to change the default values...