Swirl Angle Calculation

krrishcfd · March 8, 2010, 06:57

Can any one help me in finding the swirl angle in Ansys CFX Post ... before the fluid enters the impeller inlet ...

AliTr · March 9, 2010, 18:04

use the following CEL expression to create a variable which represents the Swirl Angles in any plane.

LIBRARY:
CEL:
EXPRESSIONS:
SwAnglePlane = acos((Velocity u *Normal X + Velocity v * Normal Y + Velocity w *Normal Z)/Velocity)
END
END
END

USER SCALAR VARIABLE:SwAngle
Boundary Values = Conservative
Calculate Global Range = Off
Expression = SwAnglePlane
Recipe = Expression
Variable to Copy = Pressure
END

mwmalkawi · November 4, 2021, 03:34

May i ask what is the reference form where the below formula was taken and are you confident it works and provide the pre-swirl angle because i am facing the same problem and appreciate your help

SwAnglePlane = acos((Velocity u *Normal X + Velocity v * Normal Y + Velocity w *Normal Z)/Velocity)

March 8, 2010, 06:57	Swirl Angle Calculation	#1
krrishcfd New Member KrishnaMohan.Siddu Join Date: Mar 2009 Location: Pune Posts: 8 Rep Power: 17	Can any one help me in finding the swirl angle in Ansys CFX Post ... before the fluid enters the impeller inlet ...

March 9, 2010, 18:04		#2
AliTr Member Ali Torbaty Join Date: Jul 2009 Location: Sydney, Australia Posts: 72 Rep Power: 16	use the following CEL expression to create a variable which represents the Swirl Angles in any plane. LIBRARY: CEL: EXPRESSIONS: SwAnglePlane = acos((Velocity u Normal X + Velocity v Normal Y + Velocity w *Normal Z)/Velocity) END END END USER SCALAR VARIABLE:SwAngle Boundary Values = Conservative Calculate Global Range = Off Expression = SwAnglePlane Recipe = Expression Variable to Copy = Pressure END camestha likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Netgen] Import netgen mesh to OpenFOAM	hsieh	OpenFOAM Meshing & Mesh Conversion	32	September 13, 2011 05:50
spray angle calculation	Jay	Siemens	1	August 13, 2008 10:34
swirl angle	jason tolentino	CFX	2	August 6, 2008 13:26
Numerical calculation interFoam never finishes	unoder	OpenFOAM Running, Solving & CFD	9	October 18, 2005 05:00
Warning 097-	AB	Siemens	6	November 15, 2004 04:41

November 4, 2021, 03:34		#3
mwmalkawi Member Munaf Join Date: May 2019 Posts: 38 Rep Power: 6	May i ask what is the reference form where the below formula was taken and are you confident it works and provide the pre-swirl angle because i am facing the same problem and appreciate your help SwAnglePlane = acos((Velocity u Normal X + Velocity v Normal Y + Velocity w *Normal Z)/Velocity)