Definition of the theta function in CFX-PRE

c120613 · April 9, 2010, 08:52

Dear all,

In CFX-PRE the theta function is a discontinuous function because in the front of a rotor is defined from 0 to pi and from -pi to 0. The problem is that I want to define a theta function from 0 to 2*pi for overall the annulus (to define the angular position).
It may be possible to avoid the using of fortran routine, but it is quite complicate with respect to define a simple CEL expression.
Somebody can help me?

Kind regards

Domenico

ghorrocks · April 9, 2010, 09:28

This is easy using the new "if" CEL function.

ghorrocks · April 10, 2010, 07:24

He sent me a PM:

Quote:

Thank you a lot for your help. However I'd like to know which are you talking about because in ANSYS 11.0 the CEL function is not written in the manual so far and I do not have idea how to write the final expression.

I hope you can help me!!

If you are using CFX V11 then you won't have the if function. You will have to use the step function instead. It is messy, but it works.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
LiencubiclowRemodel	nzy102	OpenFOAM Bugs	14	January 10, 2012 09:53
Definition of a linear function as volScalarField	titio	OpenFOAM Running, Solving & CFD	1	October 3, 2010 17:51
Periodicity of a function (loop) CFX	uorinopuot	CFX	2	October 27, 2009 20:15
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 21:50
Problem with rhoSimpleFoam	matteo_gautero	OpenFOAM Running, Solving & CFD	0	February 28, 2008 07:51

April 9, 2010, 09:28		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 18,016 Rep Power: 146	This is easy using the new "if" CEL function.