 |
 |
 |
|
|
|
[Sponsors] | ||||
May 23, 2010, 13:21
|
Heat gases
|
#1 |
|
New Member
Join Date: May 2010
Posts: 21
Rep Power: 15  |
Actual design combustion of coal in the furnace and the movement of the material.
Created two domains in which it is modeled. The motion to simulate normal and there is no heating in combustion exhaust gases and as a consequence does not heat the material. I can not understand why no hot gases. Thank you for any advice! Last edited by Sas; May 29, 2010 at 06:43. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| Convective / Conductive Heat Transfer in Hypersonic flows | enigma | Main CFD Forum | 2 | November 1, 2009 22:53 |
| how to impose experimental dat as boundary conditi | Rogerio Fernandes Brito | FLUENT | 14 | November 25, 2008 05:47 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Linear Mode
