How to create Couvette flow in cfx?

haristrawberry · September 15, 2010, 06:19

hi,

i'm a basic learner in cfx to simulate flows!!! kindly help me!! anyone please tell how to simulate the couvette flow? how to give cfx pre conditions to simulate moving plate?

ghorrocks · September 16, 2010, 02:13

This is all covered in the tutorials which come with CFX <CFXROOT>/examples and the tutorials available on the ANSYS customer page.

haristrawberry · September 16, 2010, 07:08

oh!! okay!!! will see it and try

Jade M · September 21, 2010, 12:11

I think you are referring to "Couette" rather than "Couvette." Correct spelling may help you in searching.

Simply apply the usual no-slip condition. However, the option for Wall Velocity needs to be checked and then the value for the velocity needs to be entered.

Good luck.

haristrawberry · September 23, 2010, 07:26

yea!!! its mistake!!! i did it!!! thank u!!

September 15, 2010, 06:19	How to create Couvette flow in cfx?	#1
haristrawberry New Member Hari Krishnan Kumar Join Date: Sep 2010 Posts: 13 Rep Power: 15	hi, i'm a basic learner in cfx to simulate flows!!! kindly help me!! anyone please tell how to simulate the couvette flow? how to give cfx pre conditions to simulate moving plate?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Different flow pattern between OpenFOAM and CFX	AirS	OpenFOAM	0	January 12, 2010 07:08
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07
in CFX, how to define a inlet condition of feedback control flow rate ?	suihenry	CFX	12	May 14, 2009 17:59
Define outlet with varying flow reistance in CFX	Coriolius	CFX	1	October 29, 2004 17:31
Calculation of ratational flow in CFX	Yves	CFX	1	January 27, 2004 16:48

September 16, 2010, 02:13		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	This is all covered in the tutorials which come with CFX <CFXROOT>/examples and the tutorials available on the ANSYS customer page.

September 16, 2010, 07:08		#3
haristrawberry New Member Hari Krishnan Kumar Join Date: Sep 2010 Posts: 13 Rep Power: 15	oh!! okay!!! will see it and try

September 21, 2010, 12:11		#4
Jade M Senior Member Join Date: Feb 2010 Posts: 148 Rep Power: 17	I think you are referring to "Couette" rather than "Couvette." Correct spelling may help you in searching. Simply apply the usual no-slip condition. However, the option for Wall Velocity needs to be checked and then the value for the velocity needs to be entered. Good luck.

September 23, 2010, 07:26		#5
haristrawberry New Member Hari Krishnan Kumar Join Date: Sep 2010 Posts: 13 Rep Power: 15	yea!!! its mistake!!! i did it!!! thank u!!