Temperature dependent on air properties

Reto · September 9, 2010, 11:25

Hello,

I am working on natural convection on a vertical heated plate. I set the plate temperature high (~700 K), so it seems that the flow over the plate is turbulent flow. These are my questions:

1. Most of properties for Air 25 C have constant value. Is there the built-in properties of the air depending on temperature?

2. What value of y+ should I use in meshing procedure for simulating the viscous sublayer?

Please give me suggestions. Thank you in advance!

ghorrocks · September 9, 2010, 18:52

1) No. You will have to define it yourself.
2) You need to do a sensitivity study to establish this. Are you sure you need to model the sublayer? You might be turbulent enough that wall functions are OK and then meshing is much easier.

September 9, 2010, 11:25	Temperature dependent on air properties	#1
Reto New Member WIROTE Join Date: Jul 2010 Posts: 2 Rep Power: 0	Hello, I am working on natural convection on a vertical heated plate. I set the plate temperature high (~700 K), so it seems that the flow over the plate is turbulent flow. These are my questions: 1. Most of properties for Air 25 C have constant value. Is there the built-in properties of the air depending on temperature? 2. What value of y+ should I use in meshing procedure for simulating the viscous sublayer? Please give me suggestions. Thank you in advance!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with zeroGradient wall BC for temperature - Total temperature loss	cboss	OpenFOAM	12	October 1, 2018 06:36
Temperature dependent thermal property in CFX	Subhadeep	CFX	5	March 22, 2012 01:52
air properties - heat expansion?	phsieh2005	Main CFD Forum	1	November 25, 2007 09:17
Kinetic air props model - conductivity HALF?	Chris Bailey	FLUENT	1	March 7, 2006 10:38
AIR molecular properties	Julie Polyakh	Siemens	3	January 5, 2002 16:25

September 9, 2010, 18:52		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	1) No. You will have to define it yourself. 2) You need to do a sensitivity study to establish this. Are you sure you need to model the sublayer? You might be turbulent enough that wall functions are OK and then meshing is much easier.