[m.maneshi]

Sponsored Links

Dear all

Here i m trying to prametrize the blade curves generated in BLADEGEN 12.0 to be used in an optimization process, same as the way done in mechanical designs and etc. but i cant figure out how to do it? what parameters should i define and how ?

Regards

[claco]

Originally Posted by m.maneshi

Dear all

Here i m trying to prametrize the blade curves generated in BLADEGEN 12.0 to be used in an optimization process, same as the way done in mechanical designs and etc. but i cant figure out how to do it? what parameters should i define and how ?

Regards

Hi,

did you manage to do that? I'm encountering the same problems (I have to change the Bezier control points of the profile curves, at each span station)

Yours sincerely,

Claudio

[m.maneshi]

Originally Posted by claco

Hi,

did you manage to do that? I'm encountering the same problems (I have to change the Bezier control points of the profile curves, at each span station)

Yours sincerely,

Claudio

No, I could not get over it, I just switched to NUMECA,
good luck with that.