Validation of surface roughness model approaching a hydraulically smooth surface

jola · October 11, 2010, 07:46

We have used the surface roughness model in CFX previously on transitionally rough surfaces with fairly good results.

Now we are studying a case where the surface is just on the limit between hydraulically smooth and transitionally rough. Has anyone done any validations of the surface roughness model in CFX for this type of almost smooth surfaces?

jola · October 20, 2010, 10:06

I'm responding to myself here. We have digged out some measurement data for a case with two different surface roughness values - one is almost hydraulically smooth and one is a bit rougher and transitionally rough most of the time.

Although the model does not predict the correct absolute losses the loss-trend when changing surface roughness seems to be fairly well captured with this model. We are running it with resolved boundary layers. The loss trend is what we were most interested in. We want to assess if it is worth the extra cost to polish theses surfaces to mirrors or if we should devote our effort to other problems instead (welds, tolerances, ...).

The fact that the absolute numbers are not matching is probably due to problems of comparing apples to apples - measuring loss in a boundary layer is difficult and comparing measured loss with CFD results in a consistent manner is also difficult.

October 11, 2010, 07:46	Validation of surface roughness model approaching a hydraulically smooth surface	#1
jola Administrator Jonas Larsson Join Date: Jan 2009 Location: Gothenburg, Sweden Posts: 824 Rep Power: 10	We have used the surface roughness model in CFX previously on transitionally rough surfaces with fairly good results. Now we are studying a case where the surface is just on the limit between hydraulically smooth and transitionally rough. Has anyone done any validations of the surface roughness model in CFX for this type of almost smooth surfaces?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mixture model validation cases	Antoine	Main CFD Forum	1	January 24, 2011 01:02
model validation	phil	CFX	0	March 18, 2005 12:25
Cavitation Model Validation	Neil	Main CFD Forum	0	January 8, 2004 08:47
Surface tension - Continuum Surface Force model	Robert	Main CFD Forum	0	May 2, 2002 07:34
Turbulence model in flow driven by surface tension	Z. ZENG	Main CFD Forum	7	April 28, 1999 07:18

October 20, 2010, 10:06		#2
jola Administrator Jonas Larsson Join Date: Jan 2009 Location: Gothenburg, Sweden Posts: 824 Rep Power: 10	I'm responding to myself here. We have digged out some measurement data for a case with two different surface roughness values - one is almost hydraulically smooth and one is a bit rougher and transitionally rough most of the time. Although the model does not predict the correct absolute losses the loss-trend when changing surface roughness seems to be fairly well captured with this model. We are running it with resolved boundary layers. The loss trend is what we were most interested in. We want to assess if it is worth the extra cost to polish theses surfaces to mirrors or if we should devote our effort to other problems instead (welds, tolerances, ...). The fact that the absolute numbers are not matching is probably due to problems of comparing apples to apples - measuring loss in a boundary layer is difficult and comparing measured loss with CFD results in a consistent manner is also difficult.