VOF in ANSYS CFX

enghamed · December 24, 2010, 05:01

Hi all,
Does any one has or know tutorilas on VOF in ANSYS CFX. I'm using 12.1 version and probably could move to 13.
My end goal is to model water sloshing in a storage tank under siesmic forces. Any suggestion on this will be appreciated as well. Should I use changing the gravity vector or moving wall B.C. or moving mesh?

Regards;
Hamed

ghorrocks · December 25, 2010, 04:08

Look at the flow over a bump tutorial.

Search the forum for water sloshing simulations posts. It has been asked many times.

December 24, 2010, 05:01	VOF in ANSYS CFX	#1
enghamed Member Hamed Join Date: Jun 2010 Posts: 43 Rep Power: 15	Hi all, Does any one has or know tutorilas on VOF in ANSYS CFX. I'm using 12.1 version and probably could move to 13. My end goal is to model water sloshing in a storage tank under siesmic forces. Any suggestion on this will be appreciated as well. Should I use changing the gravity vector or moving wall B.C. or moving mesh? Regards; Hamed

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solidification in Ansys CFX (12.0 )	mauricio	CFX	2	August 11, 2015 09:06
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 06:27
ANSYS CFX Tutorial	Rashid	CFX	25	December 20, 2012 01:22
"ANSYS CFX" and "CFX TascFlow"	ROOZBEH	CFX	2	December 13, 2005 01:37
CFX bought by Ansys - good or bad?!	Pete	CFX	38	February 21, 2003 07:34

December 25, 2010, 04:08		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,696 Rep Power: 143	Look at the flow over a bump tutorial. Search the forum for water sloshing simulations posts. It has been asked many times.