Surface with double boundary condition

Marcopolopeich · January 14, 2011, 10:32

Hello to everyone!
My modelling of thermal plasma goes further on...

I need perhaps a little help from some experienced users.
I need to model a surface as an interface (through which current flows) and as as Inlet (for some passive variable).
Is that possible?
Thanks for any suggestion.

ghorrocks · January 15, 2011, 07:38

Yes. Put a source term on the interface for the passive variable to do what you like to it.

Marcopolopeich · January 16, 2011, 11:41

I thought about it, thanks!
The results are quite strange, but I am doing som good progress.
Thynk you again for your help.

January 14, 2011, 10:32	Surface with double boundary condition	#1
Marcopolopeich New Member Hugo Heinz Peich Join Date: Oct 2010 Location: Switzerland Posts: 11 Rep Power: 8	Hello to everyone! My modelling of thermal plasma goes further on... I need perhaps a little help from some experienced users. I need to model a surface as an interface (through which current flows) and as as Inlet (for some passive variable). Is that possible? Thanks for any suggestion.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
External Radiation Boundary Condition for Grid Interface	CFD XUE	FLUENT	0	July 9, 2010 02:53
Missing math.h header	Travis	FLUENT	4	January 15, 2009 12:48
boundary condition at free surface	mike	NUMECA	3	June 8, 2006 06:23
The Boundary Condition about the Flat Plate	boing	Main CFD Forum	1	January 6, 2002 17:53
solid surface boundary condition	qlr	Main CFD Forum	4	November 3, 1999 00:09

January 15, 2011, 07:38		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 13,535 Rep Power: 104	Yes. Put a source term on the interface for the passive variable to do what you like to it.

January 16, 2011, 11:41		#3
Marcopolopeich New Member Hugo Heinz Peich Join Date: Oct 2010 Location: Switzerland Posts: 11 Rep Power: 8	I thought about it, thanks! The results are quite strange, but I am doing som good progress. Thynk you again for your help.