 |
 |
 |
|
|
|
[Sponsors] | ||||
March 17, 2011, 01:32
|
blood pump
|
#1 |
|
New Member
ranjith
Join Date: Dec 2009
Posts: 19
Rep Power: 17  |
i am simulating flow in a centrifugal blood pump. while estimating the mass flow rate through the washout holes(washout holes are holes near the axis of the pump intended to prevent stagnation of blood near the axis) i am getting a value which is twice the expected value). I got this using the mass flow tool in the function calculator. Any ideas on such a deviation....I am using a rotational frame of reference for the impeller and a static frame of reference for the sorrounding medium with a frozen rotor interface
ranjith |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Assistance in Vacuum pump simulation | enr_venkat | CFX | 5 | November 20, 2012 12:50 |
| Regenerative pump modelled in FLOEFD pro | YYY | FloEFD, FloWorks & FloTHERM | 2 | October 5, 2009 06:04 |
| A pump paradox | bearcat | Main CFD Forum | 7 | July 14, 2009 21:02 |
| blood flow simulation start-up hints please | olumide olododo | Main CFD Forum | 4 | May 31, 2004 12:33 |
| Discharge pump flow | Ali | Main CFD Forum | 0 | March 5, 2003 18:11 |
Linear Mode
