fluid material setting in evaporator modeling

mogoko · March 20, 2011, 07:44

Hi to all,
I'm modeling a heat exchanger with phase change, there're two kinds of fluid in two channels between which a plate conducts the heat flux.
I find that the materials of fluid are settled as the same kind automatically in CFX...... How should I set them respectively?
Thank you.

mogoko · March 20, 2011, 11:09

now i know how to set it...

daksh ajmera · October 23, 2018, 12:12

Quote:

Originally Posted by mogoko

Hi to all,
I'm modeling a heat exchanger with phase change, there're two kinds of fluid in two channels between which a plate conducts the heat flux.
I find that the materials of fluid are settled as the same kind automatically in CFX...... How should I set them respectively?
Thank you.

can you please tell me how did you solve this problem?
I am facing the same problem.

March 20, 2011, 07:44	fluid material setting in evaporator modeling	#1
mogoko New Member Neil Yang Join Date: Mar 2011 Posts: 6 Rep Power: 15	Hi to all, I'm modeling a heat exchanger with phase change, there're two kinds of fluid in two channels between which a plate conducts the heat flux. I find that the materials of fluid are settled as the same kind automatically in CFX...... How should I set them respectively? Thank you. daksh ajmera likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 00:58
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
fluid pass through a filter(pressure drop setting)	Jasica	Siemens	1	September 13, 2008 09:42
Single Bubble	Gerrit Senger	CFX	4	March 12, 2007 16:29
Warning 097-	AB	Siemens	6	November 15, 2004 04:41

March 20, 2011, 11:09		#2
mogoko New Member Neil Yang Join Date: Mar 2011 Posts: 6 Rep Power: 15	now i know how to set it...