Thin domain

mark_dynamite · May 25, 2011, 07:39

Hi, how do I insert a thin domain between two solids? I think it is in the meshing. I modelled it as one part with two bodies, if that makes a difference. Thanks for your help

mark_dynamite · May 25, 2011, 08:06

Basically I have two fluids, one hot and one cold, and I want to do a fluid-solid interface between them. I can get the fluid fluid interface, but if I try to do a fluid-solid, it says no valid domains. So I think I need to put a thin domain between them so I can do the heat transfer of a thin material. What am I missing out? Thanks

ghorrocks · May 25, 2011, 08:40

Do a fluid fluid interface and you can put a thermal resistance on the interface, to model a thin solid between two fluid regions.

mark_dynamite · May 26, 2011, 01:28

thanks! that was it, its solving now!

May 25, 2011, 07:39	Thin domain	#1
mark_dynamite New Member Mark Walker Join Date: May 2011 Posts: 3 Rep Power: 14	Hi, how do I insert a thin domain between two solids? I think it is in the meshing. I modelled it as one part with two bodies, if that makes a difference. Thanks for your help

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Domain Imbalance	HMR	CFX	5	October 10, 2016 05:57
Domain format problem on airfoil flow simulation	andrenonaka	CFX	14	December 7, 2015 00:42
CFX domain comparison	Kiat110616	CFX	4	April 3, 2011 22:43
how to set a thin layer of different material over a domain?	jehan	CFX	2	June 8, 2010 03:20
CFX Solver Memory Error	mike	CFX	1	March 19, 2008 07:22

May 25, 2011, 08:06		#2
mark_dynamite New Member Mark Walker Join Date: May 2011 Posts: 3 Rep Power: 14	Basically I have two fluids, one hot and one cold, and I want to do a fluid-solid interface between them. I can get the fluid fluid interface, but if I try to do a fluid-solid, it says no valid domains. So I think I need to put a thin domain between them so I can do the heat transfer of a thin material. What am I missing out? Thanks

May 25, 2011, 08:40		#3
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Do a fluid fluid interface and you can put a thermal resistance on the interface, to model a thin solid between two fluid regions.

May 26, 2011, 01:28		#4
mark_dynamite New Member Mark Walker Join Date: May 2011 Posts: 3 Rep Power: 14	thanks! that was it, its solving now!