FSI - Importing load (Mapping) -- CFD Online Discussion Forums

June 3, 2011, 11:33	FSI - Importing load (Mapping)	#1
moonomid New Member omid Join Date: Apr 2011 Posts: 9 Rep Power: 15	Dear I have a problem with mapping the pressure in structural. I've made a very good mesh in CFX and I have used the same methods and sizing in structural part ,too. But when I import the force then the percentage of mapping is not going further than 30 %. Could you please give me some tips about getting better map? and How can I make time go faster for importing the loads? (sometimes it takes 1 day for importing the loads). And we sometimes see that " 100% of Mechanical nodes were mapped to the CFD surface." but when we check the data, the values are different, therefore what can we do for getting better values? Regards gmt likes this.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Structural force in FSI mapping Fluent 12.0	benjamon	FLUENT	1	October 24, 2011 10:32
FSI - verification force mapping with mfx	Vinzent	CFX	15	September 18, 2011 18:00
How to simulate FSI with harmonic load	nabeh	CFX	0	August 17, 2010 18:47
Importing .sfe load files from CFX to Ansys ADPL	Eyezac	ANSYS	0	May 14, 2010 18:09
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 08:19

All times are GMT -4. The time now is 15:32.