CFX Total force problem

momozzzz · July 15, 2011, 09:33

Hi there,
I have been doing a 2D simulation of an ahmed bluff body. Meshed in ICEM and run in CFX. ive tried a veriety of different meshes and they all seem to affect the total force as if the ''edges'' are part of the geometry. This problem can be seen in the attachment. The velocity and pressure contour plots seem fine.
If any one can help me i would be greatful as im new to CFD!

Thanks,
Mohammed

stumpy · July 15, 2011, 09:54

Force is roughly pressure * area, so the total force will depend on the area of each "face" in the contour plot. When looking at force you usually look at an area weighted integral on a wall boundary.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with zeroGradient wall BC for temperature - Total temperature loss	cboss	OpenFOAM	12	October 1, 2018 06:36
Calculating lift force of a wind turbine blade problem	LittleBart	CFX	4	June 29, 2011 02:33
CFX pressure in Simulations problem	nasdak	CFX	1	April 14, 2010 13:22
problem in displaying surfaces in CFX	haho	CFX	1	July 5, 2009 19:25
total pressure in CFX	Atit Koonsrisuk	CFX	0	January 1, 2005 05:46

July 15, 2011, 09:54		#2
stumpy Senior Member Join Date: Apr 2009 Posts: 531 Rep Power: 21	Force is roughly pressure * area, so the total force will depend on the area of each "face" in the contour plot. When looking at force you usually look at an area weighted integral on a wall boundary.