Home > Forums > Software User Forums > ANSYS > CFX

porous and mesh motion

Mark Forums Read

Reply

Search this Thread

August 22, 2011, 21:39	porous and mesh motion	#1
enghamed Member Hamed Join Date: Jun 2010 Posts: 43 Rep Power: 17	Hi, I have modeled a sloshing tank with mesh motion in ANSYS 12.1. now i have added a part in the tank which is porous. but the porous setting doesnt allow to specify mesh motion. What should I do? thx

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Effects of mesh on results of FLUENT modeling using porous jump model	newcomer	FLUENT	1	June 25, 2012 02:13
Problem in defining porous region on an imported tetrahedral mesh	run_cfd	OpenFOAM Pre-Processing	0	May 24, 2011 03:15
Dynamic Mesh and Porous Media Modelling	vidya	FLUENT	0	July 29, 2009 09:34
Porous zone+heat generation+tetrahedral mesh	Nicolas Ruiz	FLUENT	0	July 31, 2008 17:46
Simulation of a flow through porous mesh in fluent	G.Vijaya Rama Reddy	FLUENT	0	September 14, 2006 01:35

All times are GMT -4. The time now is 00:59.