 |
 |
 |
|
|
|
[Sponsors] | ||||
September 8, 2011, 11:27
|
problem in parallel run in Workbench
|
#1 |
|
Member
Mina
Join Date: Apr 2011
Posts: 88
Rep Power: 15  |
Dear CFX users
I want to run some thing parallel with 16 cores on cluster, i am using ANSYS WORKBENCH, but when i want to run it in Define run> Run Mode i selected HP disterbuted parallel , and then select one bullx and increased partition to 8 but after that when i wanted to add the new one as you can see in the picture "host name" part is emty while it wasn't like that before, and i was able to add another bullx with another 8 paritions, Does any body familiar with that ? problem.jpg |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
| nonNewtonianIcoFoam - problem with parallel run | chris_sev | OpenFOAM Bugs | 4 | April 1, 2009 09:13 |
| Parallel run with engineFoam | francesco | OpenFOAM Bugs | 1 | November 25, 2008 07:06 |
| Problem on Parallel Run Setup | Hamidur Rahman | CFX | 0 | September 23, 2007 17:11 |
| parallel problem | rui | Siemens | 2 | July 31, 2007 13:23 |
Linear Mode
