FSI - wind-induced vibration of plate -- CFD Online Discussion Forums

September 21, 2011, 06:54

FSI - wind-induced vibration of plate

colopolo

Member

Join Date: Aug 2011

Posts: 70

Rep Power: 16

Hi All,

I simulate wind-induced vibration of plate using FSI (transient structura - CFX)

In Structural, I defined remote displacement of side of plate. (see Fig2).
the condition of remote displacement is x: 0, Y: free, z: 0, rot-x: 0, rot-y: 0, and rot-z:Free. Because I would like to see vibrate at Y-dir and rotate z-dir. (it is same condition of wind tunnel test).

but, I have an error of CFX via FSI.
1. Mesh folded error. I alread poted thread about this error but still problem.

ANY IDEAS are welcome

Attached Images

	fig1.jpg (31.8 KB, 17 views)
	fig2.jpg (34.3 KB, 18 views)

Last edited by colopolo; September 22, 2011 at 20:59.

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FSI - Wind Turbine	AUN	CFX	13	August 29, 2012 17:44
Free vibration of plate	colopolo	FLUENT	0	September 8, 2011 03:51
vibration of a rotating plate in water	zhm	Main CFD Forum	0	March 2, 2010 19:50
Simulation of Flow induced vibration on an elastically mounted bluff body in a cross	pradeepta	FLUENT	2	September 17, 2009 08:18
FSI oscillating plate	spatialtime	CFX	4	April 29, 2009 16:04

All times are GMT -4. The time now is 13:02.