|January 11, 2012, 23:40||
Creating locations in CFD-Post using a macro
Join Date: Jun 2010
Posts: 10Rep Power: 8
I want to create a plane in Ansys CFD-Post using a macro.
I am familiar with the macro syntax. However in the user guide
I cannot find the CEL command to create a plane: is it possible or not?
Thanks in advance
|January 12, 2012, 05:35||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 12,837Rep Power: 100
Yes, it is possible. To get the syntax go to the GUI and record a session file where you make a plane. Then the session file will contain the syntax.
|cel, locations, macro|
|Thread||Thread Starter||Forum||Replies||Last Post|
|User CEL Function and CFD Post||chastain||CFX||4||September 24, 2013 13:58|
|Enthalpy calculation in cfd post||bharath||CFX||0||October 7, 2011 22:14|
|CFX Post: Problem with Macro||Shafiul||CFX||12||January 5, 2011 16:24|
|Poly lines in CFD Post||ashtonJ||CFX||0||December 2, 2010 03:46|
|creating expresions in cfx build or cfx post||alex||CFX||1||August 22, 2002 13:01|