CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   CFX (https://www.cfd-online.com/Forums/cfx/)
-   -   CFX solver problem, ERROR #001100279 (https://www.cfd-online.com/Forums/cfx/96902-cfx-solver-problem-error-001100279-a.html)

gooya_kabir February 4, 2012 10:15
CFX solver problem, ERROR #001100279
 
Hello,
I run a multiphase model, continuous water with dispersed solid. transient mode and particle model were selected. after running it, it doesn't solve at all and stop in the first step. the following message appear:
ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| Stopped in routine GET_GVAR |
| |
| |
| |
| |
| |
+--------------------------------------------------------------------+
+--------------------------------------------------------------------+
| An error has occurred in cfx5solve: |
| |
| The ANSYS CFX solver exited with return code 1. No results file |
| has been created.
I changed the mesh characteristics and timesteps to 0.00001 s, but it doesn't work.:( would you guide me in this problem?:)
thanks a lot for your time

ghorrocks February 5, 2012 17:22
There is an error in your setup. You are not defining somthing which is required.

gooya_kabir February 6, 2012 03:40
User guide problem
 
As you told, I check the all models, except one case, nothing was wrong.
:in
A.NSYS C.FX-Pre U.ser's G.uide | D.omains | U.ser I.nterface | Surface Tension Force Model
has come that: You must also specify a Surface Tension Coefficient and select the Primary Fluid. but there is no surface tension coefficient in fluid pair models or elsewhere!!!!
what's wrong do you think?

ghorrocks February 6, 2012 19:07
Have you done the tutorials on multiphase flow? That shows you how to set these simulations up.

gooya_kabir February 7, 2012 02:55
I did all!!!
 
there is no tutorial for dispersed solid!!!
would you tell me that should set a surface tension coefficient in dispersed solid? there is no empty box for it!!!
it maked me crazy:(

gooya_kabir February 7, 2012 03:01
help
 
would you give me an example, address of site or send it to me

Suman Sapkota May 24, 2018 05:15
same problem but solved
 
Hello,
I am not sure if it is relevant now. But anyways, I encountered the same problem and I changed the particle solid to user from the material group. the problem is gone.

The particle solid specifies the thermodynamic property of the dispersed phase as solid but when user defined, we can do that by choosing pure substance and thermodynamic property as solid. From this option, we don't need to input surface tension coefficient and the problem vanishes.


All times are GMT -4. The time now is 20:55.