|
[Sponsors] |
February 8, 2012, 00:00 |
Streaks in the Turbulent boundary layer
|
#1 |
New Member
farzin
Join Date: Jan 2012
Posts: 6
Rep Power: 14 |
Hi
is it possible to see the Low and high speed streaks in the turbulent boundary layer of a flat plate ( free stream speed = 2 m/s) ? |
|
February 16, 2012, 08:43 |
|
#3 | |
Member
Tom
Join Date: Jan 2012
Location: France
Posts: 43
Rep Power: 14 |
Quote:
Excuse me, but how do you set the boundary condition to have the boundary layer and what's the solver you are using? My case is SIMPLEFOAM and the backward facing step mesh... |
||
February 16, 2012, 17:04 |
|
#4 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
If you are using openfoam then you should post on that forum.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 00:35 |
Velocity in a Turbulent boundary layer | fisch | OpenFOAM Programming & Development | 0 | August 17, 2011 10:21 |
Turbulent boundary layer resolution | deji | OpenFOAM | 2 | June 15, 2011 13:57 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Boundary Layer Meshing of a nosecone | Chris | FLUENT | 1 | March 15, 2005 12:42 |