problem in convergence

shaswat · February 20, 2012, 01:15

Dear friend

I am doing blood flow through stenosed artery. I consider the arterial wall as porous domain
wall has multiple layers which has different porosity and permeability

I have written permeabity and porosity as a function of r

it is steady state analysis. I am facing the convergence problem .I need your help

Thank you

Regards

Shashwat

ghorrocks · February 20, 2012, 01:52

Use a much smaller timestep to start off, and possibly local time scale factor (set it to about 5). Run that for a while until it starts to converge, then switch back to physical time scale with a larger time step to convergence.

These are all standard tricks for getting convergence, read the documentaton on "Obtaining Convergence".

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
convergence problem when use pisoFoam, LES for wind tunnel case	Forrest_Lei	OpenFOAM	3	July 19, 2011 07:00
convergence problem	commonyue	Main CFD Forum	1	December 1, 2009 04:54
Convergence of CFX field in FSI analysis	nasdak	CFX	2	June 29, 2009 02:17
3D Fluid Flow Convergence problem	Emily	FLUENT	2	March 21, 2007 23:18
Non Convergence of 3D Heat transfer cfd problem	Balraj	Main CFD Forum	3	December 9, 2004 01:24

February 20, 2012, 01:52		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 18,011 Rep Power: 146	Use a much smaller timestep to start off, and possibly local time scale factor (set it to about 5). Run that for a while until it starts to converge, then switch back to physical time scale with a larger time step to convergence. These are all standard tricks for getting convergence, read the documentaton on "Obtaining Convergence".