|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Billy
Join Date: Mar 2012
Posts: 3
Rep Power: 14 ![]() |
At the end of the simulation, I received the following error. I ran this same model many times and have not seen the error like the one below. Please help.
+--------------------------------------------------------------------+ | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | create_indextable: stored index is wrong: missing start tag | | | | | | | | | | | +--------------------------------------------------------------------+ +--------------------------------------------------------------------+ | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | iif_open: unable to read the stored index, attempting to rebuild | | it | | | | | | | | | +--------------------------------------------------------------------+ +--------------------------------------------------------------------+ | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | recreate_indextable: warning: file was not closed correctly, data | | may be inconsistent | | | | | | | | | +--------------------------------------------------------------------+ |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Rose buda
Join Date: Jan 2017
Posts: 2
Rep Power: 0 ![]() |
I got the same error, after trying to restart a run from a backup file...
Still no solutions? Thanks |
|
![]() |
![]() |
![]() |
![]() |
#3 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,901
Rep Power: 144 ![]() ![]() ![]() ![]() |
The message is cryptic and guessing what it means without context is difficult. So it is hard to help with the little information presented.
I am guessing here - but it could be to do with the material properties table generation, and that the setup of the table is not correct. But this is only a guess.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
gamma-ReTheta turbulence model for predicting transitional flows | FelixL | OpenFOAM Programming & Development | 123 | August 30, 2022 12:50 |
Doxygen documentation | Tanay | OpenFOAM Installation | 9 | September 23, 2011 12:40 |
OpenFOAM install on Ubuntu Natty 11.04 | bkubicek | OpenFOAM | 13 | May 26, 2011 06:48 |
CFX 10's solutions differ from CFX 5.7's | Atit Koonsrisuk | CFX | 4 | July 26, 2006 12:59 |
CFX Post Table Generation | Claudia | CFX | 1 | July 25, 2006 08:32 |