|April 2, 2012, 03:40||
mass flow through different pitch angles
Join Date: Jul 2010
Posts: 152Rep Power: 8
I want to launch the calculation with different pitch angles (90deg vs. 180deg). My question is: Do I have to specify mass flow through this interface or it is automatically calulated from pitch ratio?
I just specified pitch angles but I have imbalance of mass flow between inlet/outlet which is not negligible.
All replies apriciated. Thanks a lot.
|April 4, 2012, 07:46||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 13,313Rep Power: 103
I do not think pitch angle is taken into account for mass flow boundaries.
If you have a large imbalance that is a convergence issue, not a pitch angle issue.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Convergence problem with target mass flow rate||ADL||FLUENT||2||May 29, 2012 21:11|
|Discrete Phase & Mass Flow Rate||MagnusZeus||FLUENT||0||December 2, 2011 18:57|
|Mass Flow Rate||student87||CFX||4||January 2, 2010 05:45|
|mass flow||Wenbin Song||FLUENT||0||September 27, 2005 13:00|
|Mass Flow Inlet||Pravir Kumar Rai||FLUENT||0||February 19, 2003 15:03|