|April 4, 2012, 07:46||
A problem of simulation using ICEM CFD Replay Remeshing
Join Date: Apr 2012
Posts: 1Rep Power: 0
I try to use the icem CFD Replay Remeshing to simulate this case： the vertical is vabrate when it is rotating. the model is as following:
it composed by four part:the vertical part,the vebrating part,the up and down static part.
then now I do it as tutorials step by step,I creat the files: .tip and .rpl
but when a cfx-solver run to remshing,the icem start automatic and it get the fault.it said as: wrong.gif[/IMG]
can give any advice about what's the cause of this probleam,and how to fix it (I use ansys 13.0,is it the problem of istalltion). thank you very much.
the other probleam is how to prview the motion of mesh(to check the motion of mesh is right or not) .
thank you !
|icem cfd replay remeshing|
|Thread||Thread Starter||Forum||Replies||Last Post|
|icem cfd ai environment 11.0, laptop keyboard problem, linux||pertupd||Hardware||3||October 3, 2011 08:27|
|User defined remeshing vs ICEM CFD replay remeshing||vmlxb6||CFX||0||October 18, 2010 01:58|
|ICEM CFD --- Spaceball problem||Andrea||CFX||2||May 23, 2007 23:43|
|ANSYS ICEM CFD: lsdyna input file creation problem||Evan||CFX||0||June 15, 2006 13:12|
|Problem with ICEM CFD 5.0||sac||CFX||4||October 15, 2004 11:28|