Home > Forums > Software User Forums > COMSOL

Volume of mesh cell in Comsol

Mark Forums Read

Reply

Search this Thread

May 24, 2014, 08:45	Volume of mesh cell in Comsol	#1
IndrajitPW New Member Indrajit Join Date: May 2014 Posts: 2 Rep Power: 0	Dear ComSOl users, I am trying to model a two pphase flow in Comsol and require the volume of the mesh cell for a certain source term in the equation. Since Comsol is a finite element method, is it possible? And if yes, how does oe obtain that? Regards, Indrajit

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
Negative cell volume detected, dynamic mesh	tony25800	FLUENT	6	September 17, 2014 19:50
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
negative cell volume in dynamic mesh	WU zhonghua	FLUENT	0	July 28, 2004 10:04

All times are GMT -4. The time now is 22:09.