What mean by "preset species data' and 'outflow' settings in plasma model

tomchiah · November 21, 2023, 13:09

Hi all, I tried look around to find out what these two settings means, but unfortunately, I could not find any. Did anyone know what means by these 2 as shown in the picture attached? These are species settings under plasma model
Screenshot 2023-11-22 010342.jpg

aminem · December 26, 2023, 07:29

I't to fill parameters (molar mass, Potential characteristic lenght, ...) bu the value existing in COMSOL library.

tomchiah · December 26, 2023, 09:05

In this case, how do i know which species to set with respectively?

aminem · December 27, 2023, 03:26

It's depending of the species you ar setting. For Ar+ you can put Ar. If the species not existing in COMSOL data base you should put all parameter manually.

tomchiah · December 27, 2023, 09:14

Yes, this is referring to preset species data. But how about outflow, inflow, symmetry and flux settings?

November 21, 2023, 13:09	What mean by "preset species data' and 'outflow' settings in plasma model	#1
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 4	Hi all, I tried look around to find out what these two settings means, but unfortunately, I could not find any. Did anyone know what means by these 2 as shown in the picture attached? These are species settings under plasma model Screenshot 2023-11-22 010342.jpg

December 26, 2023, 07:29		#2
aminem Member amine Join Date: Jan 2014 Location: FRANCE Posts: 84 Rep Power: 13	I't to fill parameters (molar mass, Potential characteristic lenght, ...) bu the value existing in COMSOL library. tomchiah likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
outflow data	love T-mac	FLUENT	0	May 21, 2005 13:13

December 26, 2023, 09:05		#3
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 4	In this case, how do i know which species to set with respectively?

December 27, 2023, 03:26		#4
aminem Member amine Join Date: Jan 2014 Location: FRANCE Posts: 84 Rep Power: 13	It's depending of the species you ar setting. For Ar+ you can put Ar. If the species not existing in COMSOL data base you should put all parameter manually.

December 27, 2023, 09:14		#5
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 4	Yes, this is referring to preset species data. But how about outflow, inflow, symmetry and flux settings?