error parcel simulation in biofuel therm data
 

hi everyone
i simulasion engine with biofuel mech but when i insert therm.data all species there arent in predefinde liqued in parcel simulation and i see this error
must have 52 property entries for the liquid mpalm
must have 52 property entries for the liquid mstear
mpalm and mstear are bio species with c17h34o2 c19h38o2 formule and these species are in my mech and thermo data but this error has seen . my converge version is 2.3 too please helpe me how can i resolve thia error

Hello,

I offer the following suggestion : Since you're doing a spray simulation, please ensure you have these two liquid species appropriately defined in your liquid.dat [Materials > Parcel Simulation]. It looks like you might not have enough entries in your properties table for your liquids. STUDIO should tell you how many entries you require in your table, depending on the critical temperature of your liquid. If you do not have enough data points, you can always use the "Interpolate" feature to fill in the table.

Hope this helps.

Sincerely,

Srivastava

hi
thanks for your answer
i know these issue but the meaning of my telling is another issue. i dont find this species in predefined liquid in the parcel simulation for simulation biodesiel.
how can i add this species in liquid data?

Hello,

If you cannot find the required liquid species in our Predefined liquids database, you need to create a new user-defined liquid. To do this, click the Add button (green plus mark). After this, you will need to fill up the entries for the properties of your user-defined liquid. This can either be done manually, or you can make use of our Liquid Calculator to fill up the table.

For more information on this, please refer to our STUDIO manual.

Sincerely,

Srivastava