How to detect knock by using SAGE combustion model

ankitraut27 · November 5, 2017, 04:10

Hi,

I am using SAGE model for simulating GDI engine case. I want to detect knock in the engine. For this what setting I have to use with SAGE combustion model? I have advanced the spark timing and set maximum Mach CFL limit as 10. Is there anything more required to detect knock?

Thanks!

tmburton · November 8, 2017, 11:14

Ankit,

We have an advanced training session covering simulation of engine knock. Please contact support@convergecfd.com for a copy of the relevant training slides.

Best regards,

Tristan

November 5, 2017, 04:10	How to detect knock by using SAGE combustion model	#1
ankitraut27 New Member Ankit Raut Join Date: Sep 2017 Location: Chennai Posts: 14 Rep Power: 8	Hi, I am using SAGE model for simulating GDI engine case. I want to detect knock in the engine. For this what setting I have to use with SAGE combustion model? I have advanced the spark timing and set maximum Mach CFL limit as 10. Is there anything more required to detect knock? Thanks!

November 8, 2017, 11:14		#2
tmburton Member Tristan Burton Join Date: Sep 2017 Posts: 92 Rep Power: 8	Ankit, We have an advanced training session covering simulation of engine knock. Please contact support@convergecfd.com for a copy of the relevant training slides. Best regards, Tristan __________________ Tristan Burton Senior Principal Engineer CONVERGECFD

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
eddy dissipation model: combustion doesn't occur	roukaia	FLUENT	2	November 18, 2020 10:23
problem in the ECFM combustion model	Georges Thomas	CONVERGE	1	August 7, 2017 16:00
Liquid rocket engine non-premixed combustion model	Erik	FLUENT	2	November 28, 2013 14:09
eddy dissipation model: combustion doesn't occur	roukaia	FLUENT	0	December 24, 2011 09:10
combustion model	Hennie van der Westhuizen	Siemens	7	February 27, 2002 02:10