|
[Sponsors] |
November 10, 2017, 17:40 |
Fixed embedding for the spray
|
#1 |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
Hello,
I was wondering how deep should be the fixed embedding length? In the example file, it is 0.01 m. However, in my case, the spray penetration is around 0.05 m. |
|
November 13, 2017, 19:50 |
|
#2 |
Member
Tristan Burton
Join Date: Sep 2017
Posts: 92
Rep Power: 8 |
Amin,
We normally embed a short distance (0.01 m) and turn on velocity AMR at the same level as the injector embedding. However, if the parcels get into the coarser mesh before the velocity AMR kicks in (it's lagging a time step or two behind), then we increase the embed length. Best regards, Tristan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fixed bed reactor | Many | Fluent Multiphase | 2 | February 12, 2018 22:30 |
Spray fixed embedding start and end time | amin_u50 | CONVERGE | 2 | November 1, 2017 10:00 |
Can anyone suggest a good tutorial of Spray Combustion in Ansys FORTÉ? | shubhra | ANSYS | 2 | October 5, 2017 07:06 |
Fixed CL mode in SU2 V4.2 | ygd | SU2 | 0 | November 15, 2016 10:59 |
spray injection | mmacrb | FLUENT | 0 | January 10, 2007 05:57 |