|
[Sponsors] |
January 24, 2018, 22:37 |
How to delete therm.dat species list
|
#1 |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
Hello,
I'm going to delete the list of species which I imported through gas thermodynamic data. Is it possible to delete some species here? Amin. |
|
January 25, 2018, 10:14 |
|
#2 |
New Member
Join Date: Dec 2015
Posts: 27
Rep Power: 10 |
Hi Amin,
Thanks for asking about this. Yes, you can delete the species that are not being used in the simulation, however, having extra species in therm.dat does not affect the simulation. CONVERGE will look up the therm.dat data only for the species being used in the simulation and will ignore the others. If you still want to delete the extra species, you can open the therm.dat file in any text editor and delete unwanted species and the corresponding data. Thanks, |
|
January 25, 2018, 12:00 |
|
#3 | |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
Quote:
Thank you for your answer. Actually, I imported a wrong therm.dat file. When I'm going to import a new one the previous therm.dat species are still there. Sometimes I have two similar species with different thermodynamic coefficients. So, there is a ''fix duplicate'' but I'm not sure how CONVERGE keeps the one species and delete the another one. I appreciate if you could help me. |
||
January 25, 2018, 12:07 |
|
#4 |
New Member
Join Date: Dec 2015
Posts: 27
Rep Power: 10 |
Hi Amin,
Instead of doing this in the Studio, a quicker way would be to just replace the wrong therm.dat file with the correct one in your working folder. This way there should be no duplicates. Thanks, |
|
January 25, 2018, 12:09 |
|
#5 |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
||
January 25, 2018, 15:07 |
|
#6 |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
It does not matter what I have uploaded in my gas thermodynamic? CONVERGE just reads the therm.dat in the case setup file? Is that right?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[Other] How to use finite area method in official OpenFOAM 2.2.0? | Detian Liu | OpenFOAM Meshing & Mesh Conversion | 4 | November 3, 2015 03:04 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |