[E=MC2]

Hello

I am trying to run the command for mechanism reduction on CONVERGE 3.0 on local machine but I get the error below. Please advise what is wrong.



\Case setup>mpiexec -n 16 converge reduction
[mpiexec@ENG0000001287] HYD_sock_connect (..\windows\src\hydra_sock.c:235): Retrying connection, retry_count=1, retries=0
[mpiexec@ENG0000001287] HYD_connect_to_service (bstrap\service\service_launch.c:83): assert (!closed) failed
[mpiexec@ENG0000001287] HYDI_bstrap_service_launch (bstrap\service\service_launch.c:431): unable to connect to hydra service
[mpiexec@ENG0000001287] HYD_bstrap_setup (bstrap\src\hydra_bstrap.c:420): error launching bstrap proxy
[mpiexec@ENG0000001287] wmain (mpiexec.c:1878): error setting up the boostrap proxies

[Yaju]

Hi,

Are you following the workflow described in the Getting started guide?

You can get the Getting started guide from your installation directory.
<install_root>/Convergent_Science/CONVERGE/<version>/doc/Getting_Started_Guide_3.0.pdf

Generally, you need to load one of the MPI modules that comes with the installation and then try running the case.

For example: if you want to use the MPICH libraries

module load <install_root>/Convergent_Science/Environment/modulefiles/CONVERGE/CONVERGE-MPICH/<version>
mpirun -n 4 converge reduction

[E=MC2]

So I am trying to run it from Windows on local PC, even after installing the recommended MPI from the Getting_Started_Guide_3.0.pdf, but I get the error message attached. Please advise.