The amount of pressure increase in the compression stroke is too low

hudehfu · April 16, 2021, 08:47

Hello everyone：

I have the following problem

In the simulation，The max cylinder pressure is about 0.2mpa in the compression stroke，which causes no combustion.

Does anybody know why pressure is low? How to solve it?

usamaubk · April 17, 2021, 17:54

are you sure you are using correct initial conditions and boundary conditions? did you obtain IC's and BC's from experiments. Maybe the can be a problem your pressure isn't that much. also can you check your compression ratio..If its too low then it can also cause a decrease in peak pressure. that's all i can say provided you have given very little info about what case ar you dealing with.

hudehfu · April 17, 2021, 21:37

Hello, initial conditions and boundary conditions should be right, the setup process is based on the tutorial. Compression ratio is also OK to calculate in CONVERGE. What other information do you need from me to help you determine the problem? I can provide it to you.

April 16, 2021, 08:47	The amount of pressure increase in the compression stroke is too low	#1
hudehfu New Member tianyuan Xia Join Date: Apr 2021 Posts: 10 Rep Power: 5	Hello everyone： I have the following problem In the simulation，The max cylinder pressure is about 0.2mpa in the compression stroke，which causes no combustion. Does anybody know why pressure is low? How to solve it?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What is difference between static pressure and gauge pressure?	aja1345	FLUENT	1	July 20, 2018 20:05
Low pressure inlet problem	Bisht	FLUENT	10	March 28, 2018 09:04
Getting divergence while increasing the back pressure at pressure outlet	greenfields15	FLUENT	0	March 18, 2018 23:39
what the result is negatif pressure at inlet	chong chee nan	FLUENT	0	December 29, 2001 05:13
Hydrostatic pressure in 2-phase flow modeling (long)	DS & HB	Main CFD Forum	0	January 8, 2000 15:00

April 17, 2021, 17:54		#2
usamaubk Member Usama Join Date: Aug 2019 Posts: 32 Rep Power: 6	are you sure you are using correct initial conditions and boundary conditions? did you obtain IC's and BC's from experiments. Maybe the can be a problem your pressure isn't that much. also can you check your compression ratio..If its too low then it can also cause a decrease in peak pressure. that's all i can say provided you have given very little info about what case ar you dealing with.

April 17, 2021, 21:37		#3
hudehfu New Member tianyuan Xia Join Date: Apr 2021 Posts: 10 Rep Power: 5	Hello, initial conditions and boundary conditions should be right, the setup process is based on the tutorial. Compression ratio is also OK to calculate in CONVERGE. What other information do you need from me to help you determine the problem? I can provide it to you.