|
[Sponsors] |
May 10, 2021, 02:41 |
Unit of HRR
|
#1 |
Member
Yaopeng Li
Join Date: Dec 2017
Location: Lund, Sweden
Posts: 50
Rep Power: 8 |
Hello,
I just used Converge for engine calculation, and I found the unit of heat release rate in the output file "thermo.out" is "J/time", what exactly it is for engine application, J/deg, J/s, or J/ms? Thank you for your kind help. Best wishes Yaopeng |
|
May 12, 2021, 16:27 |
|
#2 |
New Member
Praveen Srikanth
Join Date: May 2021
Location: Convergent Science, Madison, WI
Posts: 19
Rep Power: 4 |
The unit for the heat release rate should depend on the crank_flag. If the simulation time is in seconds (crank_flag = 0), it would be J/s. If it is in deg (crank_flag = 1 or 2), it should be in J/deg
|
|
May 13, 2021, 04:08 |
|
#3 |
Member
Yaopeng Li
Join Date: Dec 2017
Location: Lund, Sweden
Posts: 50
Rep Power: 8 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
unit of variables in binary diffusion coefficients equation | Weiqiang Liu | FLUENT | 0 | June 6, 2020 10:20 |
the unit of molar mass in fluent | Weiqiang Liu | FLUENT | 0 | June 11, 2019 16:54 |
Grid I Unit Normal and Grid J Unit Normal | pawansut | Tecplot | 4 | July 31, 2017 18:14 |
how to caculate the mass of impacting particles per unit area and per unit time? | xyq916 | CFX | 0 | October 8, 2015 08:55 |
unit of fluent | yinyue | FLUENT | 0 | November 3, 2004 08:57 |