|
[Sponsors] |
[Need Advise] SimulationSI PFI cannot reach combustion |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 10, 2022, 19:10 |
[Need Advise] SimulationSI PFI cannot reach combustion
|
#1 |
New Member
Cahyani Windarto
Join Date: Feb 2021
Posts: 4
Rep Power: 5 |
I am a new user of converge, and trying to use converge to simulate SI-PFI.
I read converge manual and make setup fot it. But after trying some cycles, i found that our simulation cannot reach combustion stage and the pressure under 1 mpa. I am looking for your guidance and support to solve this problem. |
|
February 13, 2022, 23:13 |
|
#2 |
New Member
Cahyani Windarto
Join Date: Feb 2021
Posts: 4
Rep Power: 5 |
It was solved,
thie error because base grid size is very big |
|
February 17, 2022, 09:51 |
|
#3 |
Senior Member
Kislaya Srivastava
Join Date: Sep 2017
Location: Convergent Science, Northville MI
Posts: 165
Rep Power: 8 |
Hello Cahyani,
Glad your issues were resolved. In the future, we recommend you to adopt the case setup settings from one of our example cases similar to your case at hand. For instance, we have the SI8_engine_PFI_SAGE_transient_RANS example case from which you can refer to recommended grid settings/sizes for such cases in order to obtain accurate results. Sincerely, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modelling Combustion in Porous Zone | tanjinjack | FLUENT | 2 | September 26, 2016 04:10 |
[Need some advise] Am I doing right?? Simulating a rotational mixer | setasena | STAR-CCM+ | 4 | March 10, 2013 10:32 |