Problem with the 3D-results
 

Hello everyone!
I did a simulation of a dual-fuel engine with n-heptane and methane based on the SAGE model of the dual-fuel engine in the official example.
In the result output, the results in line plotting are from -145 to 125 degrees depending on the crankshaft rotation angle (which matches my setup for the case)
I used post-processing 3D to cover the output file, but in Tecplot, the angle of reads only -145 to 7 degrees.
How can I deal with this situation?

Can you please provide more specifics? The 3D output frequency and the frequency for *.out files is controlled differently. You can change that under Case Setup > Output/Post-Processing > output files > Writing time intervals