[Patrick1990]

Hey,
I'm Patrick from Germany. I don't speak English very well but I'll do my best.

Since yesterday I'm working with Ansys Maxwell 2D. I tried to simulate a motor with permanent magnets and now I have a few questions.

- Where can I fill in the length of my machine? I think I'll need this to get a correct result of the torque.

- Where can I change or customize the mesh?
- Do I need a mesh in the air gap? Where can I construct it?
- Is there a way to export my 2D-drawing to *.dxf?
- Is it possible to turn the rotor in the simulation?

I hope you can help me.


Greetings from Germany,
Patrick