Home > Forums > General Forums > Electromagnetics

Electrical resistance on an interface STAR-CCM+

Mark Forums Read

Reply

Search this Thread

October 28, 2020, 07:39	Electrical resistance on an interface STAR-CCM+	#1
bratgiu New Member Giuseppe Join Date: Oct 2020 Posts: 1 Rep Power: 0	Hello guys, I have a problem for my simulation conserning ohmic heating in a battery cell. I have defined two continua one for electric part (ohmnic) and solid domain for the remaing parts. Insiede electric region I have to set an electrical resistance on a specific interface (0.005 ohm). However when I set it simulation diverges. Someone can help me please? Thanks a lot. Giuseppe

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFD analaysis of Pelton turbine	amodpanthee	CFX	31	April 19, 2018 19:02
Out File does not show Imbalance in %	Mmaragann	CFX	5	January 20, 2017 11:20
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 07:28
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 21:09

All times are GMT -4. The time now is 06:05.