CFD Online Discussion Forums

CFD Online Discussion Forums (
-   EnSight (
-   -   Ensight postprocessing a LES (

AS_allways October 30, 2013 09:57

Ensight postprocessing a LES
1 Attachment(s)

i have a LES motor flow simulation loaded in Ensight10. I already changed the "part element settings" to -Border- so i can view the hole surface of the fluid.
Unfortunately the fluid looks like as a accumulation of Lego bricks as you can see in the Attachment.

Is there a way to interpolate between the edges?
If this helps, i do even have the original .stl (CAD-geometry file) including the surface where the fluid runs through.

thank you
Best regards,


All times are GMT -4. The time now is 06:48.