|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Lisa
Join Date: Apr 2017
Location: USA
Posts: 19
Rep Power: 8 ![]() |
Hi,
Is there a way to obtain different parameters (say outlet temperature) for different time-steps in the same table? ![]() ![]() I was solving the a transient temperature through a helical pipe. I loaded the results for different time steps in CFD Post processing. I am able to see the outlet temperatures at different time steps if I keep changing the default case. But is there a better way to display the temperatures for different time steps on a single table Thanking you in anticipation for your help. ![]() |
|
![]() |
![]() |
![]() |
Tags |
cfd post, temperature calculation, transient 3d |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF to calculate average temperature outlet? | h0rst | Fluent UDF and Scheme Programming | 0 | March 29, 2017 02:33 |
Inlet temperature = outlet temperature + offset? | GerHan | OpenFOAM Pre-Processing | 5 | November 14, 2016 06:36 |
outlet temperature | jigneshrohit99 | FLUENT | 1 | March 25, 2016 13:26 |
How to get the temperature gradient in CFX post | Jay | CFX | 4 | January 7, 2015 03:23 |
Question on checking incell temperature at outlet | Guoqing | Phoenics | 1 | June 4, 2003 17:50 |