Home > Forums > Visualization & Post-Processing Software > EnSight

Issue when viewing engine simulation from Converge

Mark Forums Read

Reply

Search this Thread

December 18, 2019, 05:54	Issue when viewing engine simulation from Converge	#1
MMatt Member MMatt Join Date: May 2013 Posts: 59 Rep Power: 14	After exporting an engine simulation done in ConvergeCFD, and opening it in Ensight, the geometry looks weird, see below: Any solution to this issue? Thanks in advance

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Alignment error in engine simulation	sangeeth	CONVERGE	6	February 10, 2024 03:20
Sector simulation of hcci engine	Adhavan	CONVERGE	2	March 7, 2018 08:13
From Gambit to Converge ic-engine duel fuel simulation	mohameditdh	CONVERGE	5	November 14, 2017 19:37
Simplified engine simulation	lovecraft22	OpenFOAM	1	April 14, 2012 08:18
Engine simulation	mihirmeetarbhan	ANSYS	0	January 16, 2012 20:36

All times are GMT -4. The time now is 05:27.