|
[Sponsors] |
"Automatically load parts lightweight" Message |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 28, 2013, 04:50 |
"Automatically load parts lightweight" Message
|
#1 |
New Member
WookJin Kim
Join Date: Feb 2012
Posts: 23
Rep Power: 14 |
"Automatically load parts lightweight" Message
What is it? I did as a message command. Tools -> Options -> Performance -> Automatically load Parts lightweight DISABLED! But I can't disable the "Lightweight" There is already state that I can't click. Simulation can not running lightweight component. So.. What can I do for this problem? Please Help me to say some advise.. |
|
March 20, 2013, 05:30 |
|
#2 |
Disabled
Join Date: Jul 2009
Posts: 616
Rep Power: 23 |
Hi JosephKim,
in this case it is best to contact your SW reseller and ask for his help. Your parts have to be all none lightweight for the simulation. If you unceck that option I would guess it doesn't necessarily resolve all parts. You might have to check if the parts are really not lightweight anymore and if not, then maybe try to manually deactivate the lightweight setting for these parts individually. But I'm no expert in SW. Also you could try to search the internet for this problem, maybe there is a SW forum where it was explained. I hope this helps, Boris |
|
April 22, 2013, 10:27 |
|
#3 |
New Member
WookJin Kim
Join Date: Feb 2012
Posts: 23
Rep Power: 14 |
Thank you Boris
You are advice always be of help to me. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cfd to ansys thermal to ansys structural interface | ssixr | ANSYS | 17 | July 31, 2015 16:18 |
[General] Error Message while trying to load ParaView Online Help | akku | ParaView | 2 | March 6, 2013 01:47 |
foamToVTK: load all the parts at once | lovecraft22 | OpenFOAM Post-Processing | 0 | March 18, 2012 09:59 |
single directional message transmit in parallel model | su_junwei | OpenFOAM Programming & Development | 1 | December 17, 2009 08:00 |
Error message in CFX-10 | CFDworker | CFX | 2 | October 12, 2007 08:23 |