Results from parameter study
 

Hello,
I computed one parameter study with stroke of piston as parameter.
All design points are done, and I want to observe the flowfield on a plane for each stroke.
If I load one result-set, I see the result "patched" on another grid, and the stroke of piston in't updated.
So I cannot post-process my parameter study.
Is there a workaround?
I am running 13.1 Version
Thanks a lot

Hi Maxime,

If you define the plots you want to post process before running the parametric study, then you can select them as output information as well as goals and the images are created directly after each calculation.
If you haven't done this you cannot directly do any changes in the parametric study but you can export the design points as separate projects and use the compare feature to compare a plot you created in one project and get the same plot for all projects you select in the compare feature.

Boris

Hello Boris,
Unfortunately I didn't get your last point.
I am quite lazy for computing all the design points again.

So I have one design point (project), and in this one I created my parameter study.
All my points are included in this parameter study and I am not able to call any of those points, except from "load data from", and I need then to choose one of the results included in the parameter study folder.
Attachment 37520

You can right click on the design point name in that table and use the create project. I think you can also use multi select and do that for all of them or so. I don't have the software open at the moment.

Boris

yes, I got it now.
Thank you