Flotherm heat flow inbalance
Hello,
In my simulation the heat flow balance is wrong, the net difference is equal to 0.5 [W] which corresponds to 5% of inflow :( I created two symmetry boundaries in the model, because my geometry has two symmetry planes (it's a cylinder with some cuboidal stuff inside), does it mean that those symmetry boundaries shouldn't be there? I guess I should also run simulation for a little bit longer (residuals and monitor point values are fine), and then run it on refined grid, right? Do you have any suggestions? thanks, Pawel |
progres
I created finer mesh (3milion cells) and inbalance dropped about 10times, so I guess that was the main reason.
|
All times are GMT -4. The time now is 09:48. |