parameter setting flow simulation

JaniXXX · June 8, 2021, 05:21

Hello,

I am new to the topic of flow simulations with FloEFD (using SolidEdge) and I am facing a small problem.
I want to do an internal flow simulation for which I have given an inlet flow. I also know the pressure in the system. What information do I need to put in the simulation to get the correct turbulence in the considered region?

I would be very grateful for any help.

Jani

native · July 15, 2021, 04:56

Hi Jani,

what do you mean by "correct turbulence"? You can set the volume flow rate at the inlet and static pressure at the outlet as boundary conditions, solve the project and investigate the solution variables.

Does this help?

evrenykn · August 15, 2021, 09:17

Hi JaniXXX,

If you want to make an internal flow analysis on Simcenter FLOEFD, first of all, you need to close lids and check geometry.

After the control, you can define inlet, outlet and other boundary conditions. You can select pressure or flow on inlet and outlet. I think, it's enough to start the simulation.

If you want to ask another thing, you can write here.

June 8, 2021, 05:21	parameter setting flow simulation	#1
JaniXXX New Member Jana Krü. Join Date: Jun 2021 Posts: 1 Rep Power: 0	Hello, I am new to the topic of flow simulations with FloEFD (using SolidEdge) and I am facing a small problem. I want to do an internal flow simulation for which I have given an inlet flow. I also know the pressure in the system. What information do I need to put in the simulation to get the correct turbulence in the considered region? I would be very grateful for any help. Jani

July 15, 2021, 04:56		#2
native New Member Florian Join Date: Feb 2015 Posts: 13 Rep Power: 11	Hi Jani, what do you mean by "correct turbulence"? You can set the volume flow rate at the inlet and static pressure at the outlet as boundary conditions, solve the project and investigate the solution variables. Does this help? Last edited by native; July 19, 2021 at 05:03.

August 15, 2021, 09:17		#3
evrenykn New Member Evren Yilmaz Yakin Join Date: Feb 2016 Location: Ankara, Turkey Posts: 27 Rep Power: 10	Hi JaniXXX, If you want to make an internal flow analysis on Simcenter FLOEFD, first of all, you need to close lids and check geometry. After the control, you can define inlet, outlet and other boundary conditions. You can select pressure or flow on inlet and outlet. I think, it's enough to start the simulation. If you want to ask another thing, you can write here. __________________ Best Regards, Evren

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
setting OUTLET flow rate equal to INLET flow rate	spitchers	OpenFOAM Programming & Development	0	March 22, 2018 06:33
parametric study in flow simulation	topaz	FloEFD, FloWorks & FloTHERM	1	July 13, 2015 08:50
Setting boundary conditions for simple pipe flow with flow direction changing in time	Sipher	FLUENT	1	May 4, 2015 20:05
how to get a time-accurate solution in Flow Simulation	drdet	FloEFD, FloWorks & FloTHERM	4	January 20, 2015 07:11
Expert parameter to stop the fluid flow simulation	KK	CFX	1	February 25, 2008 16:29