How to set up a simulation with layered fluids

vance · April 2, 2020, 10:15

Posting here since its my understanding that SolidWorks CFD is actually FloEFD under the hood.

I'm attempting to do a simple simulation where a single pipe will have a few "layers" of fluids in series. These will be non-newtonian "thick" fluids, and I want the starting condition to be a stack of layers, and then see how they mix as they flow slowly through the pipe. Boundaries will be a pressure on the inlet, and a flow rate on the outlet. So far, I can't figure this out. I can have the sim start with the pipe full of one fluid, and then a second fluid flow in the inlet, but I need 3 layers of fluids to see how they mix.

The software I have at my disposal is SolidWorks CFD.

Thanks, and let me know if there is a better place on this forum to post this question.

flowjoe · April 5, 2020, 13:51

Vance,
I'm posting an example problem of a Static Mixer using 3 separate HDPE non-newtonian fluids coming in at equal flow rates into a pipe. This was done by splitting the inlet surface, one for each of the 3 fluids, into equivalent areas.

Download the example model done in SW 2019 SP5.0 from here: https://bit.ly/3aNUKZq
(668 KB)

April 2, 2020, 10:15	How to set up a simulation with layered fluids	#1
vance New Member Join Date: Apr 2020 Posts: 1 Rep Power: 0	Posting here since its my understanding that SolidWorks CFD is actually FloEFD under the hood. I'm attempting to do a simple simulation where a single pipe will have a few "layers" of fluids in series. These will be non-newtonian "thick" fluids, and I want the starting condition to be a stack of layers, and then see how they mix as they flow slowly through the pipe. Boundaries will be a pressure on the inlet, and a flow rate on the outlet. So far, I can't figure this out. I can have the sim start with the pipe full of one fluid, and then a second fluid flow in the inlet, but I need 3 layers of fluids to see how they mix. The software I have at my disposal is SolidWorks CFD. Thanks, and let me know if there is a better place on this forum to post this question.

April 5, 2020, 13:51	Static mixer example	#2
flowjoe New Member Joe Galliera Join Date: Aug 2012 Location: Vermont Posts: 7 Rep Power: 13	Vance, I'm posting an example problem of a Static Mixer using 3 separate HDPE non-newtonian fluids coming in at equal flow rates into a pipe. This was done by splitting the inlet surface, one for each of the 3 fluids, into equivalent areas. Download the example model done in SW 2019 SP5.0 from here: https://bit.ly/3aNUKZq (668 KB)

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to set 2D airfoil simulation using k kl omega turbulence modele?!!	losiola	OpenFOAM	6	July 31, 2019 02:43
How to set up transient simulation for rotating parts	rusham	FLUENT	2	July 28, 2017 05:58
Ansys Licence Serve on Ubuntu 16.04 LTS	david.pasquale	ANSYS	2	January 20, 2017 11:52
Quenching simulation : how to set up a conjugate heat transfer between solid&liquid	Rockda	FLUENT	24	August 30, 2016 06:33
How to show the transient case?	H.P.LIU	Phoenics	7	July 13, 2010 04:31