batch mode
 

I would like to study the same model with different flows at the entrance. Up to now I built different konfigurations with different flows each and solved these konfigurations individually. How can one do this in a better way, e.g. a batch mode, where calculation of the next konfiguration starts automatically. In this case I needed not to get up at two in the morning to start the next run. Since the flows differ not too much it would be desirable to use the result of one run as initial condition for the next run. Where to do theese settings? Thanks in advance and best regards Peter

Re: batch mode
 

Hello,

It is quite simple to load several case in batch mode since it is a build in feature of the code.

You just have to go to the flow analysis/solve/Batch run menu and then select the cases you need to run.

You have the same options there than in a direct run (create mesh, run solver,...) and you can choose the order of the run with the up and down buttons.

I hope this will help you.

Best regards

Alain FRYDMAN

Re: batch mode
 

Thank you very much for your hint. I always thought, that the batch mode can only be used for processing the results. Best rgeards Peter Schaller