 |
 |
 |
|
|
|
[Sponsors] | ||||
November 15, 2008, 17:11
|
Flowing Intake Manifold
|
#1 |
|
Guest
Posts: n/a
|
Hello everyone I am having an issue with Floworks 2008. I have a model of an intake manifold that was designed from a plug then hollowed out with the shell command. When I try to run this object in floworks with the geometry checker there appears to be no fluid volume inside. Is this a problem with the shell command? Any help would be appreciated.
Thanks Bill |
|
|
||
|
November 16, 2008, 22:43
|
Re: Flowing Intake Manifold
|
#2 |
|
Guest
Posts: n/a
|
Define the BC's then you try the geometry check command and see the response.
|
|
|
|
||
|
November 18, 2008, 04:10
|
Re: Flowing Intake Manifold
|
#3 |
|
Guest
Posts: n/a
|
A model for internal analysis must be fully closed. If it is not closed, the fluid volume is zero. But this is not required for an external analysis.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| intake manifold simulation | uday | Main CFD Forum | 6 | December 21, 2009 01:39 |
| Intake manifold analysis | mehndan | Siemens | 3 | August 22, 2008 04:24 |
| 1D3D GT coupling :intake manifold convergence prob | Micky | Siemens | 1 | June 20, 2008 23:02 |
| Modeling of a airflow in a intake manifold | Jack | FLUENT | 1 | September 21, 2003 22:22 |
| Modeling of a airflow in a intake manifold | Jack | Siemens | 1 | September 15, 2003 05:12 |
1Likes
Linear Mode
