 |
 |
 |
|
|
|
[Sponsors] | ||||
March 31, 2013, 21:06
|
How to set roughness in flow3d?
|
#1 |
|
New Member
Join Date: Dec 2012
Posts: 9
Rep Power: 14  |
Flow3d isn't like FLUENT ,in FLUENT there is one place to set the roughness,but in FLOW3D i can't find it. Is it nessesary to set the roughness in FLOW3D? thank you!
Last edited by jacky831; March 31, 2013 at 21:10. Reason: My email is "hopochuan@163.com",if anyone want to talk about this topic,you can caontact me. |
|
|
|
|
|
April 1, 2013, 07:47
|
|
#2 |
|
Member
mahdi
Join Date: Jan 2013
Posts: 43
Rep Power: 14 |
Read technical note 60.
You can find it in website of Flow3D. |
|
|
|
|
|
|
April 2, 2013, 00:40
|
|
#3 |
|
New Member
Join Date: Dec 2012
Posts: 9
Rep Power: 14 |
ok,tahnks.
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| wall roughness with SST turbulence model in CFX10 | Vincent | CFX | 7 | September 10, 2007 17:49 |
| Install Openfoam in Suse 100 setup environment | h34gk1 | OpenFOAM Installation | 1 | September 26, 2006 21:08 |
| Problem installing on 64bit with ver13 | jonititan | OpenFOAM Installation | 5 | May 12, 2006 19:42 |
| Problem installing on 64bit with ver13 | jonititan | OpenFOAM Installation | 0 | April 28, 2006 06:45 |
| Problems with installation | jonititan | OpenFOAM Installation | 4 | November 6, 2005 05:16 |
Linear Mode
